Their response is that they see no problem. We are not against UMAX. It should slide over the left two pins as seen below. Take a look at these barcode scanners and complete your retail setup with a touch screen monitor and new cash drawer. The following factors may prevent the notifications from being sent on time or at all: If the signal is high the lower resistor will ‘pull’ extra hard, and if the signal is low the upper resistor will do its best to raise the signal.

Uploader: Tegis
Date Added: 2 September 2013
File Size: 7.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41884
Price: Free* [*Free Regsitration Required]

I tried reading different information on installing the package, but frankly i was not able to do any thing. There is a package you might need though: Sign up or log in Sign up using Google. Step 3 Move the jumper from the ‘off’ position to the ‘on’ position.

Umax Download Area

This file only is a short descripton of the umax-backend for sane! This is called the umx power because it powers the terminator. In the case of modern devices that have an internal terminator that can be turned on and off with a little switch on the back there is no need for scannr to supply this power and many on them don’t.

For each and every signal line there is one of these constructions.


Step 4 Put the scanner back together again making sure that the big ferrite beads around the cables don’t obstruct the circuit board. You can see the mechanical equivalent in real life quite easily. This other device is actually turned on.

Umax Astra 600S Flatbed Scanner

Please suggest what is imax be done next? The package installs all you need to be more precise: I suggest you hold one hand on the power-button of the scanner while you try the first scans! They made sure that there is a small jumper hidden away inside your scanner and all that you have to do is set this to ‘on’.

If you do need too loosen the connectors around the back keep an eye on how they are located so that you can put them back in atsra same way.

Remove the circuit board from the scanner. Locate the asrra close to the one SCSI connector as marked on the photo. Browse All Upcoming Auctions Have any questions about this item?

You will see that the waves are absorbed by the sponge and there are no more reflections. Thanks for the help. Please help me with loading Umax Astra Slim scanner on Ubuntu.

Please suggest what is to be done next? By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. Is there any possibility? The other resistor pulls the signal down towards the ground.


It will be hard or even impossible for someone to ‘read’ your message because the data you are sending is polluted by this reflection. Sign up using Facebook. I think as mentioned in the description USB scanners are not supported, I may never be able to use my scanner. This then only confirms the poor user’s belief that getting a SCSI bus to work is indeed ‘black magic’ as all he did is swap a few ‘identical’ things around and suddenly everything was OK again.

If one of these two things goes wrong then the poor little terminator on the back of the scanner is not getting it’s Terminator Power. S6, S12, Astra s, Astra s ans probably a few more. We have notified UMAX of this fact and that we see it as an important problem.

The waves you make will travel down the line sccanner. All pre-bidding will end at A full invoice should be emailed to the winner by the auctioneer within a day or two.